Ford Everest Next Gen (2022–Present) — Set of 6 Aluminium Bash Plates
Maximum Underbody Protection: Radiator, Engine, Transmission, Transfer Case, Fuel Tank & Lower Control Arms
Installation Manual
Combined Weight: 45.9 kg
If you're building a Next Gen Ford Everest for serious off-road touring, half-measures won't cut it. This RIVAL 4x4 Set of 6 Aluminium Bash Plates is the ultimate underbody protection package — covering everything from the radiator at the front to the fuel tank at the rear, plus the lower control arms that are so often overlooked until a bent arm ends your trip prematurely. Whether you're navigating the Old Telegraph Track, crossing the Simpson Desert, or running station tracks in western Queensland, this comprehensive set ensures nothing beneath your Everest is left exposed. The complete bundle represents outstanding value compared to purchasing each plate separately.
✓ Complete Underbody Protection
- ✓ Maximum 6-Plate Underbody Protection System
- ✓ High-Strength 6mm Aluminium Alloy
- ✓ Precision Fit for Ford Everest Next Gen
- ✓ Corrosion-Resistant Powder Coat Finish
- ✓ Ventilated Design for Optimal Airflow
- ✓ Bolt-On Installation — No Drilling Required
- ✓ Cost-Effective Bundle — Best Value Complete Set
What's Protected
-
Radiator Bash Plate — Your radiator sits at the very front of the vehicle, directly in the firing line of rocks kicked up by the front tyres and debris from the trail ahead. A cracked or punctured radiator leads to rapid coolant loss and overheating, potentially stranding you in remote areas. This plate acts as the first line of defence for your cooling system.
-
Engine Bash Plate — The engine oil pan hangs below the chassis rail, exposed to every rock shelf and embedded stone on the trail. A cracked sump means catastrophic oil loss and engine failure — the most expensive repair bill imaginable. This plate provides comprehensive coverage to the engine's most vulnerable section.
-
Transmission Bash Plate — The automatic transmission is a precision component with a thin aluminium casing. Even a moderate impact can crack the housing or damage the valve body, resulting in total drivetrain failure. This plate ensures the gearbox remains unscathed.
-
Transfer Case Bash Plate — As the central hub of the 4WD system, the transfer case splits power between axles. Sitting low and central, it's a prime target for trail rocks. Damage here means no four-wheel drive capability — a critical failure when you're deep in the bush.
-
Fuel Tank Bash Plate — The fuel tank spans a large area beneath the rear of the vehicle with limited factory shielding. A punctured tank in the Australian outback isn't just an inconvenience — it's a genuine safety emergency. This plate provides robust protection for your entire fuel supply.
-
Lower Control Arms Bash Plate — Often ignored until it's too late, the lower control arms are exposed to side impacts from rocks and logs. A bent or damaged control arm throws the vehicle's alignment out, causes uneven tyre wear, and compromises steering stability. These plates guard the arms from trail debris and side strikes.
Key Features
-
Material: Precision laser-cut, deep-stamped 6mm aluminium alloy
-
Thickness: 6mm
-
Combined Weight: 45.9 kg
-
Finish: Textured matte black powder coat
-
Mounting: Direct bolt-on to factory mounting points
-
Number of Plates: 6 (Radiator + Engine + Transmission + Transfer Case + Fuel Tank + Lower Control Arms)
-
Fitment: Ford Everest Next Gen (2022–Present)
Why Choose Aluminium Over Steel?
-
Weight Savings: Six plates add significant mass. Aluminium keeps the total under 46 kg — a steel equivalent would push well past 70 kg, eating into your GVM allowance for gear, water, and passengers.
-
Corrosion Resistance: Aluminium naturally resists rust and corrosion. After dozens of water crossings and months of coastal driving, your plates will look as good as the day they were fitted.
-
Energy Absorption: Aluminium's controlled flex dissipates impact energy across the plate surface, protecting mounting points and chassis rails from concentrated stress.
-
Modern Engineering: Deep-stamped 6mm alloy matches the protective capability of heavier steel alternatives while maintaining the weight balance modern vehicles are designed around.
What's Included
- ✓ 1x Radiator Bash Plate
- ✓ 1x Engine Bash Plate
- ✓ 1x Transmission Bash Plate
- ✓ 1x Transfer Case Bash Plate
- ✓ 1x Fuel Tank Bash Plate
- ✓ 1x Lower Control Arms Bash Plate
- ✓ Complete Mounting Hardware & Fitting Kit
- ✓ All Necessary Bolts & Fasteners
- ✓ Installation Instructions
Installation
-
Difficulty: Easy to Moderate — suitable for experienced home mechanics
-
Requirements: Basic hand tools, vehicle ramps or jack stands
-
Bolt-On Design: All six plates utilise factory mounting points — no drilling, cutting, or permanent modifications
-
Recommendation: Install the complete set in one session for maximum efficiency — allow approximately 3–4 hours
Built for Australian Conditions
Australian off-road conditions are among the most demanding on the planet. From the razor-sharp limestone of the Nullarbor to the submerged boulders in Daintree river crossings, every track presents new threats to your underbody. RIVAL 4x4 bash plates are designed and tested for exactly these environments. The corrosion-resistant powder coat finish handles years of salt air exposure on the West Australian coast, relentless tropical humidity in the Top End, and the abrasive red dust of central Australia. The ventilated design maintains optimal component temperatures during extended low-range work in 40°C-plus conditions.
Perfect For
-
Expedition Touring: Total underbody protection for extended outback trips where mechanical failure simply isn't an option
-
Coastal & Beach Driving: Rust-proof aluminium handles salt water, sand, and tidal debris without deterioration
-
Tradies & Fleet Vehicles: Comprehensive protection for Everests working on rural properties, mine roads, and construction access tracks
-
Hardcore Off-Roading: Maximum coverage for rock crawling, technical descents, and competition-level trails
-
Daily Driving with Total Peace of Mind: Protection against road debris, speed bumps, and whatever the daily commute throws your way
Compatibility
Precision-engineered for the Ford Everest Next Gen (2022–Present), including:
- Ambiente, Trend, Sport, Platinum
- 2.0L Bi-Turbo Diesel (4-cylinder)
- 3.0L V6 Turbo Diesel
- Automatic Transmission, 4WD
Also compatible with Ford Ranger Next Gen and VW Amarok (2023+) — verify via individual product listings.
Why RIVAL 4x4?
-
Australian-Based Operations & Support: Local team delivering real support from people who know Australian 4WDing
-
Globally Engineered. Locally Proven: World-class design validated on Australia's most demanding tracks
-
High-Strength Aluminium Construction: Premium 6mm alloy — the ideal balance of strength, weight, and durability
-
Fast Australia-Wide Dispatch: Quick shipping from our Australian warehouse to anywhere in the country
-
National Dealer & Installation Network: Professional installation available through our network of authorised dealers nationwide
The Ultimate Underbody Armour Package
Maximum protection. Minimum compromise. Get the full 6-plate set and leave nothing exposed. Order now!