Ford Everest Next Gen (2022–Present) — Set of 5 Aluminium Bash Plates
Complete Underbody Protection: Radiator, Engine, Transmission, Transfer Case & Fuel Tank
Installation Manual
Combined Weight: 41.9 kg
When you invest in a Next Gen Ford Everest, you're investing in one of Australia's most capable family touring wagons. But factory underbody protection leaves critical components exposed to the rocks, stumps, and debris that litter every serious off-road track in this country. This RIVAL 4x4 Set of 5 Aluminium Bash Plates delivers comprehensive coverage from radiator to fuel tank, turning your Everest into a properly armoured expedition vehicle ready for Cape York's telegraph track, the Gibb River Road, or wherever the red dirt takes you. Buying the complete set means every vital component is protected — and you save compared to purchasing each plate individually.
✓ Complete Underbody Protection
- ✓ Complete 5-Plate Underbody Protection System
- ✓ High-Strength 6mm Aluminium Alloy
- ✓ Precision Fit for Ford Everest Next Gen
- ✓ Corrosion-Resistant Powder Coat Finish
- ✓ Ventilated Design for Optimal Airflow
- ✓ Bolt-On Installation — No Drilling Required
- ✓ Cost-Effective Bundle — Save vs Individual Plates
What's Protected
-
Radiator Bash Plate — The radiator is your engine's cooling lifeline. Positioned at the front of the vehicle, it's the first component exposed to flying rocks and trail debris. A punctured radiator means instant overheating and a stranded vehicle. This plate deflects frontal impacts and keeps your cooling system intact.
-
Engine Bash Plate — The engine oil pan and sump sit dangerously low beneath your Everest. A single rock strike can crack the sump, causing rapid oil loss and potential engine seizure. This plate provides a robust shield across the entire engine underside.
-
Transmission Bash Plate — Your automatic transmission housing is a precision-machined aluminium casing that cannot tolerate impacts. Damage to the transmission pan results in fluid loss and complete drivetrain failure. This plate guards the gearbox from underneath.
-
Transfer Case Bash Plate — The transfer case distributes power between front and rear axles — it's the heart of your 4WD system. Positioned centrally beneath the vehicle, it's exposed to rocks on every trail. A cracked transfer case means no four-wheel drive when you need it most.
-
Fuel Tank Bash Plate — Your fuel tank carries up to 80 litres of diesel and sits beneath the rear of the vehicle with minimal factory protection. A punctured fuel tank in remote Australia is a life-threatening emergency. This plate provides peace of mind on every kilometre of unsealed road.
Key Features
-
Material: Precision laser-cut, deep-stamped 6mm aluminium alloy
-
Thickness: 6mm
-
Combined Weight: 41.9 kg
-
Finish: Textured matte black powder coat
-
Mounting: Direct bolt-on to factory mounting points
-
Number of Plates: 5 (Radiator + Engine + Transmission + Transfer Case + Fuel Tank)
-
Fitment: Ford Everest Next Gen (2022–Present)
Why Choose Aluminium Over Steel?
-
Weight Savings: With five plates on board, weight adds up fast. Aluminium's 40% weight advantage over steel keeps you well within GVM limits — essential for loaded touring vehicles.
-
Corrosion Resistance: Aluminium won't rust, even after repeated water crossings and exposure to coastal salt spray. It naturally forms a protective oxide layer that steel simply cannot match.
-
Energy Absorption: Aluminium flexes on impact, distributing force across the plate rather than transmitting sharp impacts to your chassis and mounting points.
-
Modern Engineering: Deep-stamped 6mm aluminium alloy provides comparable protection to steel at significantly less weight — engineered for the demands of modern 4WD vehicles.
What's Included
- ✓ 1x Radiator Bash Plate
- ✓ 1x Engine Bash Plate
- ✓ 1x Transmission Bash Plate
- ✓ 1x Transfer Case Bash Plate
- ✓ 1x Fuel Tank Bash Plate
- ✓ Complete Mounting Hardware & Fitting Kit
- ✓ All Necessary Bolts & Fasteners
- ✓ Installation Instructions
Installation
-
Difficulty: Easy to Moderate — suitable for home mechanics
-
Requirements: Basic hand tools, vehicle ramps or jack stands
-
Bolt-On Design: All five plates mount to factory points with no drilling, cutting, or permanent modifications
-
Recommendation: Install all five plates in a single session for the most efficient fitment — allow approximately 2–3 hours
Built for Australian Conditions
From the tropical river crossings of Cape York to the rocky descents of the Victorian High Country, Australian tracks test every millimetre of your vehicle's underside. RIVAL 4x4 bash plates are engineered to absorb repeated impacts from jagged rocks, hidden stumps, and washout debris season after season. The powder coat finish resists corrosion from salt air along the Great Ocean Road, tropical humidity in the Daintree, and the fine red dust that penetrates everything in the outback. Ventilated design ensures critical components maintain proper operating temperatures even during extended low-range crawling in summer heat.
Perfect For
-
Family Touring: Protect your Everest on extended outback trips where breakdowns put the whole family at risk
-
Coastal Driving: Corrosion-proof aluminium handles beach tracks and salt-laden air without degradation
-
Tradies & Commercial Use: Essential armour for Everests working on station tracks, mine sites, and rural properties
-
Serious Off-Roading: Full underbody coverage for rock crawling, rutted tracks, and technical descents
-
Daily Protection: Safeguard against speed bumps, debris, and poorly maintained suburban roads
Compatibility
Precision-engineered for the Ford Everest Next Gen (2022–Present), including:
- Ambiente, Trend, Sport, Platinum
- 2.0L Bi-Turbo Diesel (4-cylinder)
- 3.0L V6 Turbo Diesel
- Automatic Transmission, 4WD
Also compatible with Ford Ranger Next Gen and VW Amarok (2023+) — check individual listings for confirmation.
Why RIVAL 4x4?
-
Australian-Based Operations & Support: Local team, local warehouse, real people who understand Australian 4WDing
-
Globally Engineered. Locally Proven: Advanced CAD design validated on Australia's toughest tracks
-
High-Strength Aluminium Construction: Premium 6mm alloy — light, strong, and rust-proof
-
Fast Australia-Wide Dispatch: Shipped promptly from our Australian warehouse direct to you
-
National Dealer & Installation Network: Professional fitting available through authorised installers across the country
Total Underbody Armour for Your Everest
Stop worrying about what's underneath. Shield every critical component with the complete 5-plate set. Order now!
